Solid PSE Tulipwood

This product is machined in-house out of American Tulipwood.

Our unprocessed tulipwood usually arrives in lengths between 2.4m - 3.9m, if you have specific length requirements then you may make a request in writing (via an email), however we must emphasize the fact that we cannot guarantee specific lengths. (The minimum length we sell is 2.4m)

Please note that the machining process will reduce the overall size of your selected ash timber by roughly 5mm off of both the width and thickness of the timber and for any width selected over 270mm wide your timber will be machined in sections and joined together, this enables us to achieve wider sections of timber and at the same time provides overall structural strength.

All of our solid square edge timber is supplied with a smooth machined finish ready to apply the finishing product of your choice.

Since timber is a natural product, each section may contain a different grain pattern, colour, natural figuring, and some small pin knots.
Additionally, it's important to consider the potential for imperfections such as split or splintered ends. To accommodate these imperfections and ensure you have the necessary length for your project, we advise that you allow for approximately 300mm of extra length beyond the actual usable length. This extra length provides a buffer to trim off any ends that may not meet your quality standards, ensuring that you can work with the highest quality sections of timber for your specific needs.
By accounting for this additional length, you can better manage the inherent variability in timber and achieve a more precise and aesthetically pleasing result in your woodworking projects.